To enhance the natural colours of concrete, masonry and natural stone materials while protecting them against penetration of water, oil and most staining substances. This in turn helps with long term protection against environmental impacts that cause degradation in exposed conditions.
HOW TO SPECIFY:
All exposed surfaces shall be treated by 2 coats of DeepSeal 50. The application rate varies with different materials, however usage rate per coat for most surfaces range from 1 Litre = 4m2 for porous surfaces to 7m2 for more dense materials. All surfaces to be clean and dry, and all concrete must be well cured before application.
HOW TO USE PRODUCT:
Apply two even coats of DeepSeal 50 to surface with a brush, roller, lambs wool applicator or low-pressure spray. Allow drying between coats (approximately 20 – 30 minutes depending on ambient temperature). When rolling avoid material build up at edges and don’t over work.
Highlighted natural colours of concrete and natural stone, 100% UV effective. The surfaces treated become water repellent and sealed against most staining substances, such as motor oil, red wine and mild food acids without a glossy look. Being a penetrating material is long wearing and easy to maintain
All natural unpainted masonry, concrete, most natural stones and pressed clay surfaces (test samples recommended).
All tools and equipment should be cleaned thoroughly with acrylic lacquer thinners, or discarded.
Any excess material should be mopped up from surface and not allowed to pond and dry.
DeepSeal 50 will give many years of protection; however life expectancy will depend on the surface and environment in which it is placed.
This material contains class 3 hydrocarbon solvents, contact with skin and eyes should be avoided. Should not be inhaled or consumed. Should contact occur, flush thoroughly with clean water and refer to the manufactures MSDS.