REQUIREMENT:
The protection of concrete, paving and masonry against penetration of water, oil and most staining substances, whilst slightly enhancing the natural colours of the surface. This will in turn helps with long term protection against environmental impacts that cause degradation in exposed conditions.

HOW TO SPECIFY: 
All exposed surfaces shall be treated by 2 coats of DeepSeal 25. The application rate varies with different materials, however usage rate per coat for most surfaces range from 1 Litre = 4m2 for porous surfaces to 7m2 for more dense materials. All surfaces to be clean and dry, and all concrete must be well cured before application.

HOW TO USE PRODUCT: 
Apply two even coats of DeepSeal 25 to surface with a brush, roller, lambs wool applicator or low-pressure spray. Allow drying between coats (approximately 20 – 30 depending on ambient temperature).

EFFECTS:  
Being a unique combination of Silane-siloxanes and Acrylic liquids, surfaces treated become water repellent and sealed against most staining substances, such as motor oil, red wine and mild food acids.

WHERE RECOMMENDED: 
All plain or coloured concrete, natural unpainted masonry, and pressed clay surfaces (test samples recommended).

CLEAN UP: 
All tools and equipment should be cleaned thoroughly with acrylic lacquer thinners, or discarded.

CAUTION: 
Any excess material should be mopped up from surface and not allowed to pond and dry and dealt with according to the Material safety data Information

SERVICE LIFE: 
DeepSeal 25 will give many years of protection; however life expectancy will depend on the surface and environment in which it is placed.

HANDLING PROCEDURES:
This material contains class 3 hydrocarbon solvents, contact with skin and eyes should be avoided. Should not be inhaled or consumed. Should contact occur, flush thoroughly with clean water and refer to the manufactures MSDS.