REQUIREMENT:
To enhance the natural colours of concrete, masonry and
natural stone materials while protecting them against penetration of water,
oil and most staining substances. This in turn helps with long term protection
against environmental impacts that cause degradation in exposed conditions.
HOW TO SPECIFY:
All exposed surfaces shall
be treated by 2 coats of DeepSeal 50. The application rate varies with
different materials, however usage rate per coat for most surfaces range from 1
Litre = 4m2 for porous surfaces to 7m2 for more dense materials. All surfaces
to be clean and dry, and all concrete must be well cured before application.
HOW TO USE PRODUCT:
Apply two even coats of
DeepSeal 50 to surface with a brush, roller, lambs wool applicator or
low-pressure spray. Allow drying between coats (approximately 20 – 30 minutes depending
on ambient temperature). When rolling avoid material build up at edges and
don’t over work.
EFFECTS:
Highlighted natural colours of concrete and natural
stone, 100% UV effective. The surfaces treated become water
repellent and sealed against most staining substances, such as motor oil, red
wine and mild food acids without a glossy look. Being a penetrating material is
long wearing and easy to maintain.
WHERE RECOMMENDED:
All natural unpainted
masonry, concrete, most natural stones and pressed clay surfaces (test samples
recommended).
CLEAN UP:
All tools and equipment
should be cleaned thoroughly with acrylic lacquer thinners, or discarded.
CAUTION:
Any excess material should
be mopped up from surface and not allowed to pond and dry.
SERVICE LIFE:
DeepSeal 50 will give many years of protection;
however life expectancy will depend on the surface and environment in which it
is placed.
HANDLING PROCEDURES:
This material contains class 3 hydrocarbon solvents,
contact with skin and eyes should be avoided. Should not be inhaled or
consumed. Should contact occur, flush thoroughly with clean water and refer to
the manufactures MSDS.
|
