REQUIREMENT:
To seal concrete, paving and masonry products with the view to providing
long term protection from staining, providing a water clear wet look.
HOW TO SPECIFY:
All exposed surfaces shall
be treated by 1 - 2 coats of DeepSeal AS. The application rate is determined
by consultation with a representative of Know How Concrete Technologies.
Most surfaces 1 Litre = 5 – 10 m2 per coat. All surfaces to be
clean and dry, and concrete to be 21 days of age before application.
HOW TO USE PRODUCT:
Apply a light even coat
of DeepSeal AS to surface with a brush, roller, lambs wool applicator
or low-pressure spray. Allow surface to dry between applications of
any subsequent coats.
EFFECTS:
Reduction in liquid penetration while
allowing transmission of water vapour; Resistance to staining of materials
such as oils, BBQ fat, food, etc; Enhancement of colour within the concrete;
Reduces dirt pick up and scratching / scuffing of the surface; Will
not yellow when exposed to sunlight.
WHERE RECOMMENDED:
All natural unpainted masonry,
concrete and pressed clay surfaces.
CLEAN UP:
All tools and equipment should be
cleaned thoroughly with clean water immediately after use. If dry, DeepSeal
AS may be removed with acetone.
CAUTION:
Any excess material should be mopped
up from surface and not allowed to pond.
SERVICE LIFE:
DeepSeal AS will give many years
of protection; however life expectancy will depend on the surface and
environment in which it is placed.
HANDLING PROCEDURES:
DeepSeal AS is non hazardous,
but normal hygiene should be observed following use. Avoid contact with
eyes and do not consume. The dried polymer can be hard to remove, so
the use of protective gloves, etc in recommended. Should contact
occur, flush thoroughly with clean water.
|
