HOW TO SPECIFY: 
All new concrete shall be treated by 1 coat of DeepSeal Formula at the time of placement Most surfaces 1 Litre = 8 – 10 m2 per coat. All surfaces to be free of dirt oil and grease and must be thoroughly cleaned prior to application.

HOW TO USE PRODUCT: 
Apply an even coat of DeepSeal Formula to surface by roller, lamb’s wool applicator, light bristled broom, or low-pressure spray, ensuring the area is kept moist with product for 30 minutes. Sprinkle treated area with water to reactivate, lightly broom into surface allow 30minutes and broom or squeegee off excess material.

EFFECTS: 
DeepSeal Formula creates a crystalline structure very similar to Pyrex crystal, thereby sealing the capillary structure of the concrete. It therefore reduces liquid penetration and staining possibilities; helps to prevents hairline cracking in the surface, binds and strengthens the surface thereby dust proofing and hardening it.

WHERE RECOMMENDED: 
All plain concrete. Trials should be conducted before applying to coloured concrete to ensure no effect on the coloured pigments.

CLEAN UP: 
All tools and equipment should be cleaned thoroughly with clean water immediately after use, and prior to drying.

CAUTION: 
Any excess material should be broomed from surface and not allowed to pond; otherwise a hard crystal can appear that is difficult to remove. Do not allow the material to come in contact with glass or aluminium as it will etch their surfaces.

SERVICE LIFE: 
DeepSeal Formula will give upwards of 20 years of protection; however life expectancy will depend on the surface and environment in which it is placed.

HANDLING PROCEDURES: 
DeepSeal Formula is a non-polluting, non-flammable, non-combustible product that is mildly corrosive. It does contain silicates so normal hygiene should be observed following use. Avoid contact with eyes, do not consume, and the use of protective gloves, etc in recommended.  Should contact occur, flush thoroughly with clean water. Refer manufactures MSDS