REQUIREMENT:
To seal untreated
concrete, paving and masonry products with the view to providing long term
protection from staining, without affecting natural texture or appearance.
HOW TO SPECIFY:
All exposed surfaces shall be treated by 2
coats of DeepSeal Natural ‘W’. The application rate is determined by
consultation with a representative of Know How Concrete Technologies. Most surfaces 1 Litre = 4 – 7 m2 per coat.
All surfaces to be clean and dry and free of loose materials.
HOW TO USE PRODUCT:
Apply two light even coats of DeepSeal
Natural “W’ to surface with a brush, roller, lambs wool applicator or low
pressure spray. Allow drying between coats (approximately 20 – 30 minutes
depending on ambient temperature).
EFFECTS:
Reduction in water uptake, water-vapour
permeability, concrete corrosion; Resistance to alkalis and carbons; UV
Resistance; Surface left unchanged; Lower maintenance efforts and costs.
WHERE RECOMMENDED:
All natural unpainted masonry, concrete and
pressed clay surfaces.
CLEAN UP:
All tools and equipment should be cleaned
thoroughly with clean soapy water.
CAUTION:
Any excess material should be mopped from
surface and not allowed to pond and dry.
SERVICE LIFE:
DeepSeal Natural ‘W’ should give many years
of protection; however life expectancy will depend on the surface and
environment in which it is placed.
HANDLING PROCEDURES:
DeepSeal Natural ‘W’ is not classified as
hazardous, but normal hygiene should be observed following use. It is
recommended that protective equipment be worn during use. Avoid contact with
eyes and do not consume. Should contact occur, flush thoroughly with clean
water.
|
